Kospel EPP-36 MAXIMUS Mode D'emploi page 16

Operation
Number of im-
pulses
(green indicator)
1
2
3
PL;DE;GB;FR;RU-051AB/f.794
The heater switches on automatically straight after
reaching the flow rate over 2,5 l/min. The temperature
control system selects an appropriate heating
power depending on the rate of flow, temperature
setting (set with the use of a knob on the front case)
and the temperature of water in the mains.
There are two indicators on the case:
- green – power supply "on",
- red – heating "on".
Other modes are shown by flickering green light.
The unit was switched off because the temperature has ex-
ceeded the maximum value (fault signal will not disappear
until the appropriate rate of water flow is reached).
The unit was switched off by a master appliance.
The inlet temperature sensor failure.
description
GB
13