Alecto SA241 Mode D'emploi page 15

Les langues disponibles

INSTALLATION INFORMATION:

For your own safety; before installation, ensure all mains power has been disconnected. Once the installation is fully complete, you may

reconnect the 230V mains power.

Attach the ceiling plate using the included plugs and screws to the ceiling on a location of choice. Wall mounting is not recommended for

smoke detection. Remove the plastic foil from the backup battery and place it inside the battery compartment, minding the polarity. Attach the

detachable 230V connection cable to the cables leading to the electricity meter of 230V , you may attach the white link cable to another cable

to lead to the lead-cable of any other SA-240 model to link both models. Do not attach this cable to the earthing cables.

ATTENTION. Do not switch the phase (brown) and 0-(blue) cables. The smoke detector will not function correctly if you do this.

Now plug the 230V connection cable you installed into the SA-240. The connector only fits at one single angle. Then place the detector on

the ceiling plate and twist it into place. Now reconnect the power to mains. The green LED should now light constantly. Perform a first test by

holding the test key for two seconds. Also see the paragraph: "Testing".

SLAAPKAMER

WOONKAMER

HOME-OFFICE

Brown - Connect to phase

White - Cable to connect to other smoke alarms of the same type (DO NOT attach to any

BADKAMER

SLAAPKAMER

ground cable)

Blue - Connection to 0

KEUKEN

GARAGE

9V BLOCK

HOME-OFFICE

SLAAPKAMER

KEUKEN

WOONKAMER

BADKAMER

GARAGE