Abus IPCS29511 Manuel D'instructions page 118

A new window opens; specify here on which days of the week and at which times the video tampering alarm
should be enabled.
Now select a day of the week for the video tampering. To store particular time periods, enter a start and end
time. To set up all-day video tampering, select 00:00 as the start time and 24:00 as the end time.
To enable video tampering for all days of the week, click the "Select all" checkbox. To copy the video
tampering to other days of the week, select the day of the week and click "Copy".
To apply the changes, click "OK" and to discard them click "Cancel".
Linkage Method
Here you can set the action to be performed in case of video tampering.
Normal Linkage
Send email: You receive an email as notification; check the checkbox to activate this.
Notify NVR/CMS:
FTP/SD/NAS – upload:
Other Linkage
You can switch on the alarm output when tampering is detected.
To switch on alarm output 1, select "A->1".
Apply the settings by clicking "Save".
Alarm triggering of the NVR/CMS for further processing (e.g. recording on
NVR, or full-screen display when alarm is triggered in CMS)
Enable single-image recording on FTP server, internal SD card and NAS
storage
119