Abus IPCS29511 Manuel D'instructions page 117

8.6.2 Cover Detection
With this menu item you can configure the Speed Dome so that video tampering is triggered as soon as the
lens is covered.
Area Settings
Activate video tampering alarm by clicking the "Enable video tampering" checkbox.
To select an area, click on the "Draw Area" button. The entire area is selected by default. To discard this
selection, click on "Clear All".
Drag the mouse pointer over the desired area. Set the sensitivity using the regulation control bar. To apply the
setting for the area, click on "Stop Drawing".
Right: low sensitivity level.
Left: high sensitivity level.
Arming Schedule
To save a schedule for the video tampering alarm, click on "Edit".
118