Abus IPCS29511 Manuel D'instructions page 71

Explanation of symbols
The triangular high voltage symbol is used to warn of the risk of
injury or health hazards (e.g. caused by electric shock).
The triangular warning symbol indicates important notes in this user guide which
must be observed.
This symbol indicates special tips and notes on the operation of the unit.
Important safety information
All guarantee claims are invalid in the event of damage caused by non-compliance
with this user guide. We cannot be held liable for resulting damage.
We cannot be held liable for material or personal damage caused by improper
operation or non-compliance with the safety information. All guarantee claims are void
in such cases.
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require servicing. Dismantling the product
invalidates the CE certification and the guarantee/warranty.

The product may be damaged if it is dropped, even from a low height.

Install the device so that the image sensor is not subjected to direct sunlight. Pay attention to the
installation instructions in the corresponding section of this user guide.

The device is designed for indoor and outdoor use (IP66).
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapours or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces.
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging, etc. can
pose a danger to children if played with.

The video surveillance camera contains small parts which could be swallowed and must be kept out
of the reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and user guides for the other connected devices.

Check the device for damage before putting it into operation. Do not put the device into operation if
you identify any damage.

Adhere to the normal voltage limits specified in the technical data. Higher voltages could destroy the
device and pose a health risk (electric shock).
Safety information
72