CONTENT OF DELIVERY
➢ Main unit
➢ Instruction Manual
➢ Rubber mat
➢ 45 RPM adapter
Notes about the record stylus
➢ Record styluses are precision parts, so handle them carefully to avoid bending or damaging
their tips. If a stylus becomes bent or damaged, it might not be able to follow the audio
groove precisely and could damage records or cause another malfunction.
➢ If a stylus becomes dirty, use a commercially available stylus cleaner or similar product to
clean it.
➢ Do not rub the stylus tip forcefully with anything hard. Do not wipe the stylus with thinner or
other chemicals. Doing so could harm it.
➢ Headshell & electrical connections
INSTALLING THE TURNTABLE PLATTER
1. Turntable belt and ribbon (pre-installed to the
metal platter and turntable belt)
2. To install the platter on the unit and the belt on
the pulley, please do the following:
a. Position the platter with the cutout over the
drive roller.
b. Pull the belt with the assembly tape over the
drive pulley, release one end of the
assembly tape, and remove it.
c. Keep the assembly tape together with the
instructions for later use.
ATTACHING THE TURNTABLE COVER
1. Insert the hinges completely into the hinge holders at the left and right ends of the back side
of the main unit.
2. Align the tops of the hinges with the turntable cover hinge holders and insert them.
REMOVING THE TURNTABLE COVER
Hold both edges of the turntable cover and lift it slowly to remove it along with the hinges from
the unit. Then, remove the hinges from the turntable cover.
INSTALLATION
➢ AC Adapter
➢ Dust cover
➢ Aluminum platter
2
PL780 / English Instruction Manual