Iberital Expression Pro Manuel D'installation page 66

IBERITAL
- do not allow the machine to be exposed to the elements (rain, ice, sand, etc.).
- do not expose the machine to temperatures of below 0ºC without having previously
emptied the contents of the boiler and the pipes. If the water in the interior freezes,
disconnect the machine from the water supply and let the water in the boiler and
pipes melt.
- do not expose the machine as a whole to temperatures above 70ºC.
- do not allow the machine to be manipulated by children or untrained persons, or any
person who has not read this manual.
- do not remove the machine side panels in order to reset the high-limit thermostat.
Only official technicians authorized by the manufacturer may remove the side panels
and reset the thermostat.
6. Before carrying out maintenance operations, you must ensure that the machine
is disconnected from the power grid via the switch on the power distribution
system.
7. For cleaning operations, follow the instructions contained in this manual.
8. In the case of anomalies or irregular operation, disconnect the machine prior to
carrying out any maintenance work. Contact the technical personnel authorized
by the manufacturer.
Repairs to the machine will be carried out by the manufacturer or an authorized
after-sales service centre, using only original spare parts.
If these conditions are not met, the machine will pose a danger.
The connection to the power supply must be made via a switch which meets
local safety standards.
9. The electrical supply cable for the machine must be connected to a switch with a
minimum separation between contacts of 3 mm. This switch must be covered by
an omnipolar circuit breaker.
10. In order to keep the power supply cable from overheating, ensure that it is
totally extended.
11. The mains water pressure to which the coffee machine must be connected must
be between 0.6 and 0.8 MPa.
12. The machine is only suitable for installation in places where its use and
maintenance are restricted to qualified personnel.
13. The machine must be installed in a horizontal position, and must NEVER be
submerged in water or any other liquid.
14. The power supply cable must not be repaired or replaced by the user. Should
the cable become damaged, disconnect the machine from the power supply
and contact qualified technical personnel authorized by the manufacturer.
15. Disconnect the machine from the power supply when it is not going to be used
for an extended period of time.
16. The average level of surface sound pressure is 71dB ± 7dB and the average
sound power is 86dB ± 9 dB.
17. The machine must be installed so that its highest surface is no less than 1.5
metres from floor level.
64 INSTALLATION AND OPERATION MANUAL