Operation; Using The Multi-Cooker; Weighing Food - BASETech CM-2501 Notice D'emploi

11. Operation

Refer to the instructions in "10. Inserting, removing and using the attachments" on page 28.
a) Using the multi-cooker
• Place the base station (2) on a dry, horizontal and sturdy surface (e.g. a kitchen worktop) near to a wall-mounted
mains socket. Ensure that the suction feet (7) on the bottom of the base station attach themselves to the surface.
• Place the required attachments onto the multi-cooker. For more information, see "10. Inserting, removing and using
the attachments" on page 28.
• Fill the mixing jug to at least the 0.5 L marking (no more than the MAX 2.0 L level). If you want to steam food, place
the food into the steamer.
• Place the mixing jug (with the lid on) onto the base station and lock them together.
• Fully unwind the mains cable (6) and insert the mains plug into a wall-mounted socket.
• Switch the multi-cooker on by moving the on/off switch (5) to the I position.
• You will hear a beep and the LCD display (3) will turn on. The multi-cooker is now ready to use.
• Choose a preset cooking mode, or configure the cooking settings manually.
• Press the START/PAUSE button (E) to start the cooking process. The selected cooking program will be indicated
by a flashing symbol on the LCD display:
blending/whisking.
Press the START/PAUSE button to pause the cooking process, and then press it again to resume cooking.
Press the STOPP (stop) button (D) to end the selected program.
• The multi-cooker will beep 10 times when the selected program has finished, or when the timer goes off.
• The fan will turn on to cool the motor.
• After the fan has turned itself off, move the on/off switch (5) to the O position to turn the multi-cooker off, and then
unplug the multi-cooker from the mains.
When chopping harder foods, hold down the TURBO button (F) for 10 seconds to make the multi-cooker
operate at maximum speed. Only use the turbo function in short bursts. The turbo function is not available
for cooking programs.
b) Weighing food
• Place the mixing jug (with the lid on and without the measuring cup) onto the base station (2) and lock them
together.
• Press the WAAGE (weigh) button (G). The
• Place the food that you want to weigh onto the lid, or place it into the mixing jug via the refill opening (16). The LCD
display (3) will display the weight in grams.
• To reset the scales to zero, hold down the WAAGE (weigh) button for a few seconds. You will hear a beep to
indicate that the scales have been reset to zero.
32
for heating//cooking/steaming and
symbol will flash. Wait until zero is shown on the display.
for stirring/chopping/mixing/