Setting Up The Multi-Cooker; Inserting, Removing And Using The Attachments; Mixing Jug - BASETech CM-2501 Notice D'emploi

9. Setting up the multi-cooker

• Remove all the attachments from the packaging and check that no parts are missing or damaged. Do not use the
appliance if any of the parts are damaged.
• Clean the product and the attachments to remove any factory residues. For more information, see "13. Care and
cleaning" on page 36.
• Store the tool for removing the blade unit (10) in a safe location.

10. Inserting, removing and using the attachments

Always turn off the base station (2) before removing or inserting attachments or connecting/disconnecting
the appliance to/from the mains. Insert the necessary attachments before filling the mixing jug (23) or the
steamer (12).
a) Mixing jug
The mixing jug gets hot when the multi-cooker is switched on. Exercise caution to avoid burning yourself.
Always use the handle (22) to hold the mixing jug.
Never fill the mixing jug (23) above the MAX 2.0 L marking, otherwise the contents may splash or spill onto
the surrounding surface, and you may scald yourself.
Never heat the mixing jug when it is empty, otherwise it may overheat.
Protect the heating plate (1) and the bottom of the mixing jug against splashes, dripping water and dirt.
1
• To insert the mixing jug, place it onto the heating plate (1) so that the arrow on the mixing jug is aligned with the
open lock symbol on the base station (2) (see
Turn the mixing jug clockwise using the handle (see
). The handle will click into place.
3
"E01" will be displayed on the LCD display (3) if the mixing jug is not attached to the base station
properly.
28
2
).
1
) until the arrow is aligned with the closed lock symbol (see
2
3