Publicité
Les langues disponibles
Les langues disponibles
11.2 Device-specific information
You will find the IODDs necessary for the configuration of the IO-Link device and
detailed information about sensor values, diagnostic information and parameters
in the overview table at www�autosen�com�
11.3 Parameter setting tools
You will find all necessary information about the required IO-Link hardware and
software at www�autosen�com�
11.4 Functions
With IO-Link all functions and measured data are available that can also be
accessed via the display and pushbuttons on the unit�
The process data value includes the measuring distance and the object reflectivity�
All functions are described in detail in the IODD�
12 Set-up / operation
► After installation, electrical connection and programming, check whether the
unit operates correctly�
> If the unit has been correctly set up, the distance to the object is indicated�
Lifetime of a laser diode: 50000 hours
12.1 Error indications
Display
Too much light, e�g�
[- |- ]
[--]
Not enough light, no object
Object to be measured
[nEA]
outside the measuring range
Object to be measured
[FAr]
outside the measuring range
[OFF]
Laser is switched off
Possible cause
reflective surface
< 25 mm
> 330 mm
Switching output
[Hno]
[Hnc]
[Fno]
ON
OFF
OFF
ON
ON
OFF
OFF
ON
OFF
ON
UK
[Fnc]
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
High
51
Publicité
