Autosen AL009 Notice D'utilisation page 43

10 Parameter setting
During parameter setting the unit remains internally in the operating mode� It
continues its monitoring function with the existing parameters until the change has
been completed�
10.1 General parameter setting
10.1.1 Setting a parameter value
Set the display unit [Uni] before the values for the parameters are defined�
In case of subsequent changes of the display unit rounding errors during
internal conversion to other units may falsify the set values. → 10.2.1
Selection of the display unit�
Select parameter
► Press [ENTER] to access menu level 1�
1
► Press the "up"/"down" button until the
requested parameter is displayed�
Set parameter value
► Press [Enter] briefly�
> The current parameter value is
displayed�
► Press the "up" or "down" button and
keep it pressed�
> The current parameter value flashes
2
for 3 s�
► Increase the setting value step by
step by pressing the button once or
continuously by holding it down�
Decrease the value: let the display move to the maximum setting value� Then the
cycle starts again at the minimum setting value�
Confirmation of the parameter
value
► Briefly press [ENTER]�
3
> Back to menu level 1
> The parameter is displayed again; the
new parameter value is effective�
UK
43