Tineco PURE ONE S15 Serie Mode D'emploi page 27

Warning:
• The power brush contains electrical
components which must not be soaked or
washed with water.
• Turn the power off and remove the battery before
performing maintenance for the brush roller.
• To reduce the injury, do not touch the brush
roller while the appliance is in working condition.
TROUBLESHOOTING
Problem
The appliance does
not turn on
Weak suction power
Abnormal sounds or
plastic teeth tangled
in brush
Suction mouth blocked
Battery won't charge
Brush roller tangled
indicator blinking
Power indicator
blinking
Solution
Charge the battery
Restart after cooling
down
Check and remove
blockages
Clean the dustbin and
filters
Install the pre-filter
Remove blockages
Clean the brush roller
Pull out the brush roller
and remove blockages
Remove the mesh
filter, clean the suction
mouth and dustbin
Reinsert the adaptor
correctly
Check the main
body and battery are
correctly placed
Use the original
adaptor
Remove blockages
Remove blockages, or
restart
Problem
Air channel blocked
indicator blinking
Dust sensor
malfunction indicator
blinking
WiFi indicator is off
Battery indicator
blinking red on work
Battery indicator &
icon blinking red
during charging
Battery icon on screen
blinking green
during charging
Abnormal motor
sounds
Note:
If the above troubleshooting guide fails to
provide a solution, please visit our website
www.tineco.com for further support.
WARRANTY
2-YEAR LIMITED WARRANTY
• Only applies to purchases made from
authorized retailers of Tineco.
• Is subject to the adherence of the requirements
outlined in this instruction manual, and is
subject to further conditions outlined below.
• This warranty is governed by and construed
under the laws of the country in which the
purchase took place. We provide 2-year
warranty or a warranty period as stipulated by
applicable local law, whichever is longer.
WHAT IS COVERED?
• Your Tineco appliance has a 2-year warranty
against original defects in material and
workmanship, when used for private household
25
Solution
Remove blockages
Clean the dust on the
inner sensor
Follow the in-app
guide to connect to
WiFi
Remove the battery
pack and let it cool
Use the original
adaptor
Install the battery
on the main body
properly
Remove blockages