Tineco PURE ONE S15 Serie Mode D'emploi page 26

Fully charged (Battery 100%)
In 5 mins
Battery icon & Battery
indicator: solid green.
Tineco indicator: illuminated.
After 5 minutes: all indicator
lights turn off.
Battery icon blinking green:
No battery pack or battery
pack installed incorrectly.
Both blinking red: fault.
MAINTENANCE
Note:
• Clean the dustbin and filters after each use.
• To maintain high performance, wash and dry
the pre-filter monthly, replacing it every 6
months. Wash and dry the HEPA filter every 3
months, replacing it every 12 months.
Dustbin, Mesh Filter and
Pre-filter
1.Turn counter-clockwise to remove the filters.
Fig.E-1
2.Do not turn the appliance upside down when
removing or installing the filter to prevent dust
from entering the motor.
Fig.E-2
3.Clean the dustbin and mesh filter with a damp
cloth or the cleaning tool. Air dry completely
before reinstalling.
Fig.E-3
4.The pre-filter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-4
5.After cleaning, insert the pre-filter into the
mesh filter properly and it clicks into place.
Install the clean filters back into the main body,
then close the dustbin flap.
Fig.E-5
HEPA Filter
1.Pull out the HEPA filter (in magnetic design) for
cleaning. Do not use the appliance without first
installing the HEPA filter.
Fig.E-6
2.The HEPA filter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-7
Dust Sensor
• To avoid dust accumulation which can affect
cleaning performance, wipe the suction mouth
with a damp cloth.
Fig.E-8
Mini Power Brush
1.Press against the roller end cover downward.
Fig.E-9
2.Pull out the brush roller.
Fig.E-10
3.Remove the debris wrapped around the roller
with the Tineco Hair Cleaning Tool.
Fig.E-11
4.Fully reinsert the brush roller at an angle and
push upward until it clicks securely back into
place.
Fig.E-12
Brush Head
1.With the power off, slide the switch to open
the brush roller end cover, and rotate it
counter-clockwise to pull out the brush roller.
Fig.E-13
2.After removing the brush roller, gently clean
the brush window, suction mouth and the row
of plastic teeth.
Fig.E-14
3.Fully reinsert the brush roller into the brush
window and the end cover can be rotated
clockwise until it clicks securely back into place.
Fig.E-15
24