Peg-Perego VIAGGIO 2-3 Notice D'emploi page 23

slot above the child's shoulder.
IMPORTANT: if the belt is slack,
tension it. Verify that the belt is
always tensioned and untwisted.
13• The safety belts are correctly
positioned if the child's shoulders are
below the intersection point of the
safety belts, as shown in the figure.
IMPORTANT: the safety belts
should not be too above or below
the child's shoulders.
How to remove the lining
from the bag
When removing the lining of Viaggio
2/3, do NOT detach the three
elements - headrest, backrest, seat -
but keep them together.
REMOVE THE LINING FROM THE
SEAT:
14• Detach the small hooks of
the seat bag from the points and
following the sequence shown in the
figure. Remove the central belt.
15• Remove the rigid ties as shown
in the Figure.
REMOVE THE LINING FROM THE
BACKREST:
16• Remove the rear cover by pulling
it outwards as shown in the figure.
17• Remove all the elastic straps.
18• Remove the bag.
REMOVE THE LINING FROM THE
HEADREST:
19• Remove the cover from the rear
of the headrest by pulling it outwards
and releasing the two elastic bands
as shown in the figure.
20• Remove the bag.
Maintenance of the
padding
Brush the fabric parts to remove
dust.
• M achine wash at a maximum of
30°C with a delicate wash setting
and short spin cycle.
• D o not use chlorine bleach.
• D o not iron.
• D o not dry clean.
D o not remove stains with solvents.
• D o not tumble dry.
°
30
How to reline the bag
RELINING THE SEAT:
• Insert the rigid ties in the fabric of
the seat, verifying that that the hooks
project.
• Fix the small hooks to the seat,
starting from the three more
external, insert the central belt into
the slot, then fasten the two most
internal hooks.
• Fasten the side automatic buttons.
RELINING THE BACKREST:
21• Fit the bag in place, by inserting
the lower section of the fabric behind
the headrest, as shown in the figure.
22• Fasten all the elastic straps in
23