Danfoss VLT FCM300 Configuration Rapide page 13

■ ■ ■ ■ ■ What if the motor does not start?
- Make sure no parameters have been changed from
initial delivery status (factory setting). Use the Local
Control Panel or serial port to reset to factory setting.
- Make sure no STOP command have been issued by
the optional control panel keyboard (local stop)
Control Panel STOP can only be restarted by the
Control Panel START button.
- Remove lid to check the Light Emitting Diodes visible
through a hole in the inside isolation cover (See the
drawing), follow table below.
Warning:
Extreme care must be taken when
operating the unit with open lid.
Green Yellow Red
LED 302 LED 302 LED 302 LED 302 LED 302 LED 301 LED 301 LED 301 LED 301 LED 301 LED 300 LED 300 LED 300 LED 300 LED 300
OFF OFF OFF
ON OFF OFF
ON OFF ON
ON ON ON
This Quick Setup gives information on safety and helps
you to get your FCM 300 Series motors installed and
running in factory setting, see fig. 1.
For additional information, please see the Design Guide.
Tools for installation
1 cross-point screwdriver
1 large screwdriver
1 small screwdriver
Min. 2 glands:
Gland sizes
FCM 305-330 3X PG16
FCM 340-375 1X PG21, 2X PG16
1 mains cable
1 control cable
Max. cable cross section
Mains supply cable
MG.03.A2.62 – VLT is a registered Danfoss trademark
VLT ® DriveMotor FCM 300 Quick Setup
Action
Apply power
(see point 2) (see point 2)
(see point 2) (see point 2) (see point 2)
Apply start and
reference signals ,
(see figure 1 and (see figur (see figur (see figur (see figur e 1 and e 1 and e 1 and e 1 and
point 3) point 3) point 3) point 3) point 3)
Apply reset signal
according to figure 1.
Switch off power until
all LED's have turned
off. After power on
reset signal is required.
2
4.0 mm /10 AWG
Control cable
Serial communication cable
For further information see the design guide and/or
PROFIBUS manual.
1.5 mm 2 /16 AWG
1.5 mm 2 /16 AWG
9