ITW Food Equipment Group VULCAN 924RX Manuel D'installation Et D'utilisation page 11

CONTROLS – VMG AND AGM MODELS
burner control
dial
Fig. 8
The model is equipped with standing pilots. Gas will flow from the pilots as soon as the
main gas supply to the unit is turned on. The pilots are lit with the use of an outside
ignition source (such as a lit taper, etc). There is one pilot for every two burners except
on the 36" and 60" models.
burners; therefore, one of the sets of pilots in these models will control only one main
burner. The pilots are inset 12" from the front panel. See pilot lighting procedure.
Each 12" section of the griddle is independently controlled by an infinite heat control
valve. Once the pilots are lit, turning the burner control knob counterclockwise to the full
ON position will light each burner. The burners will be in the full ON position when the
knobs are turned all the way to the left (Fig. 10). The burners will be in the OFF position
when the knobs are turned clockwise until they stop (Fig. 9). The height of the burner
flame and cooking plate temperature can be adjusted by turning the burner control knobs
while viewing burners through the burner sight holes.
Fig. 9
Burner control knob in the OFF position.
Turned all the way clockwise, indicator
aligned with "OFF"
pilot adjustment screw
The 36" and 60" models have an odd number of main
11
- -
Fig. 10
Burner control knob in the full-ON
position. Turned all the way
counterclockwise – 245 degrees from
the OFF position & indicator aligned
with "MAX"
Pilot and burner sight
holes