EIBENSTOCK EBM 250/ 2 RP Notice Originale page 99

Insert the core drill with the attached mounting plate into the drill rig and lock it with
the turnstile (see picture above).
For the operation of the core drill, its operating instructions and safety
advices have to be strictly observed!
In order to operate the tool safely, please observe the following notes:
Details of the work area
Keep the work area free of everything which could obstruct operations.
Provide for adequate illumination of the work area.
Adhere to the regulations concerning the power connection.
Lay the power cable in such a way that any damage by the drill can be avoided.
Make sure to always keep the work area in view and to be able to reach all
necessary operating elements and safety installations.
Keep other persons away from your work area in order to avoid accidents.
Space requirements for operating and maintenance
Whenever possible, keep a free space for operating and maintenance of about 2 m
around the drill position, so that you can work safely and have immediate access in
case of a failure.
The tool is supplied with a mounting plate,
a 10 mm fitting key and a 4 Allen screws M8x20.
The mounting plate is put on the drill motor with
the fitting key and fixed by means of the 4
screws.
Pay attention to the mounting direction.
Operations
15