EIBENSTOCK EBM 250/ 2 RP Notice Originale page 20

After an interruption of your work, only switch the machine on again
after having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when
you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
98
79,5
The EBM 250/2 RP is made in protection class I. In order to protect the
operator, the machine can only be run with a GFCI. For this reason, the
machine is standard equipped with a PRCD switch integrated in the cord
which allows to connect the unit directly with a grounded socket.
Attention!
! The PRCD-safety switch must not lay in water.
PRCD-safety switch must not be used to switch the tool
on and off.
Before you start working, check the proper functioning by
pressing the TEST button.
Fasten the gearing foot of the
EBM 250/2 RP by means of four M 8
Allen screws to the drill rig.
The drill stand should have a good
stiffness and precise guide ways. The
spindle of the machine needs to go
parallel to the axle of the drill stand.
Use only fall-safe drill rigs.
It is advisable to use a water-collecting
ring.
Electrical Connection
20