EIBENSTOCK EBM 250/ 2 RP Notice Originale page 101

Care and Maintenance
Always keep the drill rig clean, especially the column with the toothing and the
4 sliding pieces in the machine holder.
In order to allow the free movement of the pinion shaft, it should be slightly
lubricated.
In order to achieve a good performance of the drill rig, the 4 sliding pieces in
the machine holder have to move along the column without slackness.
Attention:
After every tenth drilling you should check if the sliding pieces have got loose-
fitting due to drilling vibration.
If the position should have changed, it can be readjusted as follows:
According to our general terms of delivery for business dealings, suppliers have to
provide to companies a warranty period of 12 months for redhibitory defects (to be
documented by invoice or delivery note).
Damages due to natural wear, overstressing or improper handling are excluded
from this warranty.
Damages due to material defects or production faults shall be eliminated free of
charge by either repair or replacement.
Complaints will be accepted only if the tool is returned in non-dismantled condition
to the manufacturer or an authorized Eibenstock service centre.
Warranty
Loosen the counter nut on the Allen screw
by means of an jaw wrench SW17
Adjust the Allen screws and the position
of the thrust piece to the column by
means of a hex head wrench.
Tighten the counter nut again and check
whether the carriage moves easily on the
column.
17