Eurocave PURE Mode D'emploi page 30

Precautions
•
Do not place your cabinet in an area liable to flood.
•
Do not place your cabinet close to a source of heat or expose it to
direct sunlight
•
Prevent water from splashing on any parts of the rear of the machine.
•
Arrange the power lead so that it is accessible and does not come into
contact with any of the appliance's components.
•
Tilt the cabinet slightly backwards in order to adjust the front feet (by
screwing or unscrewing them) so that you can level your cabinet (spirit
level recommended).
•
For single-temperature models only:
- If you notice low humidity levels (<50%) a few days after setting your
wine cabinet into operation, we recommend that you use the humidity
cartridge, supplied in a bag with the appliance. Place it at the bottom of
the cabinet, under the rack in the drip tray provided (see diagram below).
When using for the first time, completely immerse your cartridge in tap
water for a few minutes to saturate it then allow it to dry. Depending
on external conditions, it may be necessary to add a 10cl glass of water
after several months.
•
If you notice that the humidity
level is too high, remove the black
drain pipe located at the bottom
of the cabinet and the humidity
cartridge if you installed one.
If you leave your wine cabinet closed for long periods (>3 months)
in an environment where the temperature is close to your cabinet's
temperature setting (a difference of about <5°C) this could create
an environment in which mould develops or cause your bottles's
labels to peel off. Lack of dehumidification and air renewal can create
significant humidity inside the cabinet. We strongly recommend that
you regularly monitor your cabinet and clean it once a year.
•
Install the stop (which is located in the accessories bag) at the back of
the cabinet (see diagram).
•
This allows a space of 7 cm to be maintained between the wall and the
rear of the cabinet. This spa
ce allows your cabinet's power consumption to be optimised.
•
Place the 2 caps in the 2 holes at the top of the cabinet.
•
Do not push the caps all the way in, in order to allow the rear stop to
be installed.
•
Slide the rear stop between the caps and the wall of the cabinet, then
push the 2 caps all the way in.
8
GB
4/ INSTALLING YOUR WINE CABINET
Installation
Place your cabinet in the desired location.
It must:
•
be open to the outside and well ventilated (not in an enclosed
cupboard, for example),
•
not be too damp. (linen cupboard, laundry room, bathroom...). ,
•
have a flat, stable floor,
•
be supplied with power (standard outlet, 16 A, earthed with 30mA*
circuit breaker). (* not applicable to some countries).
•
Place your cabinet in the desired location.
•
Fit the charcoal filter (located in the "accessories" bag) by inserting it
into the breather hole located on the top left-hand side of the inside of
your cabinet (see diagram below).
•
Wait 48hrs before plugging in your cabinet
•
When using your cabinet for the first time, the charcoal filter alarm will
display. Reset the filter meter to 365 (see chapter 6, § VI).