Publicité
Les langues disponibles
Les langues disponibles
7 - COMMISSIONING YOUR WINE CABINET
I. Connection
- After waiting 48 hrs, plug in your cabinet, having checked that your socket is supplied with power (check the presence
of correct sized fuses, circuit breaker, in working order. If need be, plug in another electrical appliance to check that the
socket is supplied with power).
II. Single-temperature wine cabinet (ref. 3181V)
A. Description of the control panel
Temperature display g Displays the actual temperature inside
A
on/off switch g To switch on the cabinet
B
Temperature setting keys g To select the required temperature inside the cabinet
C
Confirmation key g To confirm the temperature setting
D
- To start your cabinet:
Press the «U» button, located on the control panel, until the display is activated.
When the control starts up, the message «OD» appears. Wait for the temperature to display without touching any of
the controls or unplugging the appliance.
B. Setting the temperature
Setting the temperature of your wine cabinet is carried out entirely from the control panel.
Press and hold down the
•
Set the desired temperature using the
Confirm your programming by pressing and holding down the
•
Your programming will automatically be confirmed if no button is pressed for 15 seconds after programming.
•
Your single-temperature cabinet was pre-set in the factory at I2°C but can be set between 6 and I8°C
Your wine cabinet can be placed in a room with a temperature of 0°C - 30 °C.
When commissioning the cabinet or after significant changes to the temperature setting, it can take several hours for your wine
cabinet to stabilize and display the new desired temperature. Wait a few days. If the temperature does not stabilize, contact
your retailer.
To save energy:
- Install your cabinet in a suitable place (see "Installation" paragraph) and observe the recommended temperature setting
ranges.
- Keep the door open for as short a time as possible.
- Ensure that the door seal is in good condition and check that it is not damaged. If it is, contact your retailer.
EN
-9-
button, the "SP1" symbol will appear alternately with the previous temperature setting.
and
buttons.
B
a
A
D
C
button.
Publicité
