Publicité
Les langues disponibles
Les langues disponibles
4 - CARING FOR THE ENVIRONMENT AND
Disposing of packaging:
The packaging used by EuroCave is made from recyclable materials. After unpacking your cabinet, take the
packaging to a refuse collection point. For the most part, it will be recycled.
Recycling: acaring gesture
Electrical and electronic equipment has potentially harmful effects on the environment and human health owing
to the presence of dangerous substances.
You should therefore not trash electrical and electronic equipment with
unsorted municipal waste.
When buying a new EuroCave product (wine cabinet, cellar conditioner, Vin au Verre), you can entrust recycling of your old
appliance to your EuroCave dealer.
Ask your EuroCave dealer – he will explain to you the removal and collection procedures set up within the EuroCave
network.
In compliance with legislation on protecting the environment, your wine cabinet does not contain C.F.Cs or H.C.F.Cs.
To save energy:
- Install your cabinet in a suitable place (see chapter 5) and observe the recommended temperature setting ranges.
- Keep the door open for as short a time as possible.
- Check that the door seal is in good condition and is not damaged. If it is, contact your EuroCave retailer.
N. B. When replacing your wine cabinet, contact your municipal refuse department to find out the correct
recycling procedure.
For refrigerant gases, substances and some parts contained in the wine cabinets, EuroCave uses
recyclable materials which require a special disposal procedure.
Disable unusable appliances by unplugging them and removing the power cable.
5 - INSTALLING YOUR WINE CABINET
Unpacking
• When delivered, check the outside of your cabinet for
signs of damage (impact, buckling...).
• Open the door and check that the inside of your cabinet
is intact (walls, shelves...).
• Remove the protective elements inside your cabinet.
• If there is a problem, contact your EuroCave
retailer.
IMPORTANT: When moving the cabinet, never tilt it more than 45° and always on its side, on the side of the power cable.
Precautions
• Do not place your cabinet in an area liable to flood.
• Do not place your cabinet near to a source of heat or in a
location where it will be subject to direct sunlight.
ENERGY SAVING
Installation
Transport your cabinet to its intended location.
It must:
• be open to the outside to allow circulation of air
• (not enclosed in a cupboard...),
• not be too damp (utility room, laundry room,
bathroom...),
• have a flat, stable floor,
• be supplied with power (standard outlet, 16 A, earthed
with circuit breaker, 30 mA*
• Do not allow water to splash on any part of the rear of the
appliance
• Position your appliance so that there is a minimum 5 cm -
10 cm gap between the wall and the rear wall of your cabinet.
(* not applicable to some countries).
EN
-6-
Publicité
