Publicité
Les langues disponibles
Les langues disponibles
V- Setting the lighting mode
Your wine cabinet has mood lighting which also allows you to read the bottle labels more easily.
Unlike traditional lighting, EuroCave lighting does not emit U.V. light and only generates negligible amounts of heat. Your wines
are thus stored in complete security.
Additional electricity consumption lower than 10 Watts/hour when the appliance is constantly running.
Precautions for use
To set the lighting of your Dual Zone:
Press and hold down the "set" key. The lighting and set temperature adjustment menus will light up. To navigate from one menu
to another, use the + or – keys.
Place the pointer at the level of the lighting menu ( ) and validate with the "set" key.
By navigating with the + or – keys, you then have 2 lighting setting possibilities:
- permanent lighting (for mood lighting):
- lighting disabled:
Validate the desired setting by pressing the "set" key
To make the menus appear, press then quickly release the
Your wine cabinet is fitted with several visual alarms.
A signal warns you when:
- the temperature in the cabinet has exceeded the set temperature range:
- the charcoal filter needs replacing:
In this way, your fine wines are stored in complete security.
1- Temperature
If the temperature of your cabinet is 4°C
activated.
The indicator light
remains lit until the temperature has returned within the + or - 4°C
The temperature alarm may be activated for the following reasons:
- The door has not been shut or has been shut incorrectly:
Close the door and wait a few hours for the temperature inside the cabinet to stabilise, the indicator
light will then go off.
- The door seal is damaged:
As the sealing properties of the door are not as effective, temperatures may exceed the recommended range, thus
setting off the alarm.
Contact your EuroCave dealer.
- You have placed a large number of bottles in the cabinet:
In this case, it may take several hours for the temperature in the cabinet to reach the recommended temperature, thus
setting off the alarm.
It is, moreover, possible for this phenomenon to occur when your cabinet is commissioned. It is not caused by an
operating fault.
Wait for a few days, to allow the temperature inside the cabinet to stabilise. If, on the other hand, the
alarm is still active after this period, contact your EuroCave dealer.
Excluding these 3 cases, if the alarm is activated, this may be the result of an operating fault (see following
page). Contact your EuroCave dealer.
N.B.: Only prolonged exposure to temperatures outside the recommended ranges and temperature fluctuations are harmful
to your fine wines.
: Strong light, do not look directly into the centre of the beam.
.
.
.
(7°F)
+ or - the set temperature for longer than 24 hours, a visual alarm will be
key.
.
8 - ALARMS
(7°F)
range.
-9-
Publicité
