Eurocave professional DualZone D290 Mode D'emploi page 20

- When using your wine cabinet, never pull out more than one sliding shelf at a time.
III - Adding sliding shelves
When you purchase your cabinet, the sliding shelves are set to perfectly fit the interior dimensions of your appliance. If you
purchase a new sliding shelf,
you may have to set the shelf to the desired fit yourself. To do so, unscrew the screws of the first right or left slider (2 screws)
then position the slider at
the desired width and screw the screws back on. Repeat the procedure for the second slider (if necessary):
Slider
Du Sommelier" supports can be changed or replaced. You can also add a thirteenth support: Gently detach (1) the oval section
of the support and pull it (2) towards the shelf rods.
To adjust the shelf for a new layout: gently slide the supports along the shelf. They must remain in staggered rows so that the
bottles are correctly positioned.
IV - Modifying the layout of your cabinet
To change the position of a storage shelf, first completely unload it, then move the shelf supports, ensuring that you put
them back in place, as shown opposite:
To change the position of a sliding shelf, first completely unload it. Then remove the sliding shelf by sliding it towards you
whilst lifting the front section. Remove the sliding guides from the walls, locating the right guide and the left guide, then refit it
as shown below.
Setting up the rear
part of the guide
Guide
Wall
Guide
Adjustment screw
Slider
The "Main
Guide
Wall
Setting up the front
part of the guide
Guide
Shelf
rod
1
2
Shelf support
Refitting the
sliding drawer
Wall
Wall
MDS support
Wall
Sliding
shelf
Guide
-7-