Urmet BiBus II ED K-STEEL 1072/14 Mode D'emploi page 27

Press to end the conversation with the user.
The following message will appear if the user
does not answer within the programmed off-hook
stand-by time:
does not reply
CALLS TO USERS BY SELECTING THE CODE
Select NAME
with
Dial the code of the user to be called (numeric or
alphanumeric with optional keyboard). The following
will appear on the display:
CALL TO:
n°1001
Select the code and press
user. The apartment door phone will ring for
approximately 3 seconds. Hold
up to three consecutive calls.
IN COURSE
Press to interrupt the call to the previously
selected user.
The following message will appear on the display if
the user lifts the handset:
PLEASE
Press to end the conversation with the user.
The following message will appear is the user
does not answer within the programmed off-hook
stand-by time:
does not reply
DS1072-018A
User
or
↑ ↓
to call the selected
pressed to send
CALL
TALK
User
DIRECT CALL TO CONCIERGE SWITCHBOARD
Press on a call module installed in a system with
concierge switchboard to call it directly. This is only
possible when the concierge switchboard is in day
mode, i.e. when the concierge service is operative and
the function has been activated (see "Programming").
The following message will appear on the display:
CALL TO:
Switchboard
The following will appear on the display if the button
A is pressed and either the concierge switchboard
is in night mode or the function has not be activated
(see "Programming").
CODE NOT
VALID
DOOR OPENER CODES
Press the button before entering each door
opener code. Symbol "∗" will appear on the display
when entering the code for each button. The module
will open the door if the code is valid. A warning will
be output if the code is not valid. The sequence is
the same for "Generic" and "Personal" door opener
codes: press followed by the door opener code.
The following will appear on the display:
LOCK REL. CODE
The lock will be operated and the following message
will appear if the code is correct:
Please
GENERIC DOOR OPENER CODES
The generic door opener codes can be used to directly
open the door to residents and authorised persons.
The call module is dimensioned to contain up to
eight generic door opener codes for operating the
electrical lock. The codes have four digits (no letter
permitted). The eight generic door opener codes must
be validated according to the time of day. The codes
****
Go in
27