Urmet BiBus II ED K-STEEL 1072/14 Mode D'emploi page 26

Minimum PC requirements are:
• 486 processor or higher
• Windows 95 or 98 operating system
• Use of a mouse is recommended.
The signals on the 9-pin female D-sub connector are:
Pin 1 n.c.
Pin 2 RX PC data
Pin 3 TX PC data
Pin 4 n.c.
Pin 5 Ground
Pin 6 n.c.
Pin 7 n.c.
Pin 8 n.c.
Pin 9 n.c.
Connect wire 1072/57 between module and PC
serial port to carry out the following operations:
1) Download data from PC (refer to the B-BUS
program for additional information). The following
will appear on the module.
Data reception
in course...
The module will become operative again at the end
of the operation.
2) Upload data to PC (refer to the B-BUS program
for additional information). The following will
appear on the module:
PLEASE
The module will become operative again at the end
of the operation.
VOLUME REGULATION
Volume levels are calibrated by default so not
to required adjustments in most cases. Use a
screwdriver to adjust the trimmers if required.
DISPLAY CONTRAST REGULATION
The display contrast is set at the factory and will
not need to be adjusted in most installations. Use a
screwdriver to adjust the trimmers if required.
26
WAIT
CALLS TO USERS
A user can be called by entering the user's code on
the keypad. Obviously, the code must be known to
do so. The name can be sought in the integrated
electronic directory if the code is not known.
CALLS TO USERS BY SELECTING THE NAME
The following message will appear on the display:
Select NAME
with
Press or to scroll the user's names and codes.
Hold either button pressed to scroll the names
faster. Select the name and press
selected user. The apartment door phone will ring
for approximately 3 seconds. Hold
send up to three consecutive calls.
Name/code display example:
URMET DOMUS
1001
The following prompt will appear on the display if
is not pressed for longer than two seconds after
selecting a name:
To call
press
At this point, either press
to scroll the name list.
The following will appear on the display when the
button is pressed:
IN COURSE
Press to interrupt the call to the previously
selected user.
The following message will appear on the display if
the user lifts the handset:
PLEASE
or
↑ ↓
to call the
pressed to
to call or press
CALL
TALK
DS1072-018A
or