Urmet BiBus II ED K-STEEL 1072/14 Mode D'emploi page 22

In the case of 1st edition systems, the module
will be automatically configured as a main
station and should not be changed.
The following message will appear on the display:
C. MOD. TYPE:
<MA.> <SEC>
Press and to select and press
The system will automatically go back to the main
menu after a confirmation tone.
1st edition system: this programming is not required.
Station number (ID)
A number from 1 to 12 is assigned to each main calling
station. A number from 0 to 9 is assigned to each
secondary station. The secondary number is in the
range from A to J in systems with alphabetic prefix. A to
J programmed on a secondary station will automatically
be reprogrammed as a prefix code format. ID from
0 to 9 on a secondary station will automatically be
reprogrammed as a numeric code format.
The following message will appear on the display:
== Station n°
Station
Enter the station number and press
Press to cancel the entry. The system will
automatically go back to the main menu after a
confirmation tone.
1st edition system: the station number must be in
the range from 1 to 12 (there are no secondary
stations in the system). Assign 15 as station number
to use the clone function.
Busy time
The busy time is split into two sub-menus.
The following message will appear on the display:
== BUSY TIME
PICKUP TIME
== BUSY TIME
BUSY TIME
Press and to select the sub-menu and press
to confirm.
22
to confirm.
==
1
to confirm.
==
↓
==
↑
Off-hook stand-by time
The off-hook stand-by time is the maximum time
of a call in which the user can answer the door
phone. All other calling stations will be busy during
this time. All devices in the system must have the
same off-hook waiting time. The following message
will appear on the display:
PICKUP TIME:
<10><20><30><40>
Press and to select and press
The system will automatically go back to the main
menu after a confirmation tone.
Minimum conversation time (busy)
When a user is called and answers the door
phone, all other call stations will be busy for
the minimum programmed conversation time. A
communication that has just started cannot be
interrupted. All devices in the system must have the
same minimum conversation time (busy time). The
following message will appear on the display:
BUSY TIME:
<10><20><30><40>
Press and to select and press
The system will automatically go back to the main
menu after a confirmation tone.
Door lock activation time
The relay controlling the door lock can be managed
in pulse mode (approximately 500 ms) or stabile
mode (from 1 to 30 s). The following message will
appear on the display:
= Door op. time
0 seconds
Enter the number of seconds and press
confirm. Press to cancel the entry. The system
will automatically go back to the main menu after a
confirmation tone.
Door opener codes
The eight generic door opener codes can be stored
in sequence.
The following message will appear on the display:
Lock rel. codes
1° Code:
20S
to confirm.
20S
to confirm.
=
to
DS1072-018A