Urmet BiBus II ED K-STEEL 1072/14 Mode D'emploi page 25

Refer to the attached sheet to remember the code/
button association sequence.
SEQUENZA DI ASSOCIAZIONE
ASSOCIATION SEQUENCE
N° DELLA POSTAZIONE (ID):
CALL MODULE NUMBER (ID):
SEQ. NOMINATIVO PULSANTE / CODICE
USER NAME PUSHBUTTON / CODE
1
2
3
4
5
The entire operation (booking and programming)
must be repeated for each module in the system,
unless the "Clone" function (see below) is used.
The module will quit programming mode for the
following events:
• end of door phone programming
• 10 minute time-out after the last operation
• pressing the red programming button
• pressing any module key and entering the
programming password.
How to associate 2/3 door phones in parallel in 2nd
edition systems.
To install two or three door phones in one apartment
and make them both ring when a call is received,
press related to the user twice or three times with
the door phones in parallel when booking the door
phones. When you reach the apartment where the
parallel door phones are installed according to the
programming sequence, repeat the programming
sequence on both door phones.
How to associate 2 door phones in parallel in 2nd
edition systems.
To install two door phones in one apartment and
make them both ring when a call is received,
press related to the user twice times with the
door phones in parallel when booking the door
phones. When you reach the apartment where the
parallel door phones are installed according to the
programming sequence, repeat the programming
sequence on both door phones.
Using the "clone" function in 1st edition systems.
A single association between calling station codes
and respective door phones can be made in 1st
edition systems without switchboard and without
door open signal function. The remaining call
stations can be clones of the first station (the master
station) and copy the codes associated to the single
users. To enable this function:
• define the master station as address "1" (where
to make the association).
• define all other stations as address "15".
Obviously, all names must be programmed on the
"clone" stations.
DS1072-018A
Edit password
This menu can be used to edit the password for
accessing module programming.
The following message will appear on the display:
PIANO VARIE
FLOOR VARIOUS
Enter the new 4-digit password and press
confirm.
Switchboard call enable
This menu is used to enable direct concierge
switchboard calls simply by pressing . The function
is only active when the door phone is in day mode.
The following message will appear on the display:
Press the scroll arrows to select and press
confirm.
DEFAULT PROGRAMMING
The device is pre-programmed as follows:
System type:
Station type:
Code format:
Station number:
Off-hook waiting time: 20s
Busy time:
Door opener time:
To restore default settings:
• Disconnect module power.
• Hold the red programming button pressed and
• Hold the button pressed for approximately 10
• Release the button.
PROGRAMMING VIA PC
The call module can be programmed and configured
rapidly by means of a PC connected to the serial
port (8) of the call module by means of a special
wire Ref. 1072/57 (optional, not provided with the
product).
The B-BUS PC program can be used for simple and
fast module programming. The B-BUS 2nd program
can be downloaded free of charge from the Urmet
Domus web site (http://www.urmetdomus.it).
Password:
New:
Call key
<YES> <NO>
power up the module.
seconds and wait for a tone.
9999
2nd edition
main
numeric (0001–9999)
1
20s
pulse
to
to
25