Urmet BiBus II ED K-STEEL 1072/14 Mode D'emploi page 23

Enter the 4-digit code and press
to cancel the entry. The second code can be
entered automatically after a confirmation tone. The
system will automatically return to the main menu at
the end of programming. Alternatively, press
three seconds to go back to the main menu.
Code type
The module can be used to call users with
numeric codes (0001-9999), alphanumeric codes
with alphabetic prefix (x000-x999) and alphanumeric
codes with alphabetic suffix (000x-999x). Letters
from A to J can be used.
The following message will appear on the display:
= Code Type
Num. 1.9999
= Code Type
Pref. x000.x999
= Code Type
Suf. 000x.999x
Press and to select the code type and press
to confirm.
Codes/names
The names and
programmed in this menu. The following message
will appear on the display:
= Code/Name
Enter Data
= Code/Name
Modify Data
= Code/Name
Clear All
Press and to select the sub-menu and press
to confirm.
DS1072-018A
to confirm. Press
respective codes
Enter data
The user codes and respective names and personal
door opener codes can be programmed in this sub-
menu.
for
The first free position in the 250 item table will
appear (one item for each user):
Position:
Code:
Enter the numeric or alphanumeric code formed
by a variable number of digits from 1 to 4 and
press
=
for longer than three seconds to go back to the
previous menu. The same code can be entered in
↓
two or three positions in an apartment where two
or three door phones are connected in parallel (you
are advised to use adjacent positions to simplify
=
the association). The following will appear on the
display after entering the code:
↓↑
Code 1001
=
↑
The name can be entered later. In this case, press
and enter the new code. Proceed as follows if the user
name is known. Press
keypad to seek the required character. Select the
character. The cursor will shift right by one position to
enter a new character after approximately one second
can be if no other button is pressed. Press
last entered character. Use programming keyboard
1032/65 to considerably facilitate entry of names.
The same name can be assigned to different codes.
=
Enter the name and press
door opener code. The following message will
appear on the display:
↓
Code Lock rel.
=
↓↑
Enter the personal door opener code and press A
to confirm. The general code programmed during
=
the "Door opener code" phase cannot be entered.
Press
↑
a door opener code to the user.
Editing data
The data related to the entered users can be edited
in this sub-menu. The following search criteria can
be applied:
• search by position in table (1-250);
• search by name.
1
to confirm. Press
and
to enter the respective
without entering a code to skip assigning
to correct. Press
Name:
on the call module
to delete the
23