probst FXAH-120-GREENLINE Instructions D'emploi page 31

Operation
4.3.6 Starting up
•
Slide the ON-OFF switch
•
The battery status indicator
•
If the battery status indicator
recharged before using the device, or replaced with a charged battery.
•
Working with the device when the battery is low can lead to injuries and damage to materials!
•
Position the device (FXAH-120) on the surface to be lifted.
•
To switch on the vacuum pump and trigger surface suction, the green button
Suction is performed in a matter of seconds.
•
If the sucked material is to be released again, the red button
•
The manometer
materials. If the display shows less than - 0.7 bar (- 10 psi), discard material immediately!
58500009/58500010/58500011
13 / 14
①
to the ON position to turn on the unit (FXAH-120).
②
below the power switch lights up to indicate the battery charge level.
②
flashes, the battery
⑤
must be constantly in the operator's field of vision, especially with slightly porous
V3
⑥
is not sufficiently charged and should be
③
④
must be pressed to release it.
must be pressed.
GB