Publicité
6-1. Front Panel Controls
6-2. Optional Side Panel Controls
SECTION 6 − OPERATION
1
2
3
1
2
Use Jog position to momentarily
feed welding wire at speed set on
Wire
energizing
shielding gas valve.
Use Purge position to momentarily
energize gas valve to purge air from
gun or adjust gas regulator.
3
Push up to weld without holding gun
trigger throughout the weld cycle.
To start weld cycle, press and
1
release gun trigger within three
seconds after an arc has been
struck. To end weld, press and
release gun trigger.
Power switch is on rear panel (see
Section 5-3)
2
3
1
The Run-In Speed Control provides
a means of selecting the rate at
which welding wire will feed after
preflow and before arc initiation.
After arc initiation, the wire feed
speed is governed by the Wire
Speed Control. Rotating the Run-In
Speed Control
increase run-in wire feed speed.
Close side door.
2
3
Weld cable must be routed through
reed relay switch present on units
with Run-In Speed Control option.
Wire Speed Control
Jog/Purge Switch
Speed
control
without
welding
circuit
or
Trigger Hold Switch
192 510-B
Optional Run-In Speed
Control
clockwise
will
Reed Relay Switch
Weld Cable
Ref. 802 310-B / Ref. 802 309-B
OM-193 471 Page 25
Publicité
