Publicité
5-13. Connection For Lincoln Welding Power Sources With Terminal Strip Connections
E
D
C
B
A
1
Tools Needed:
1/4 in.
5-14. Connection For AIRCO Welding Power Sources With Two-Prong Twistlock And 115
Volts AC Receptacles
E
D
C
B
A
1
Tools Needed:
1/4 in.
OM-193 471 Page 22
.
Make ground lead connections
according to Section 5-7 before
following this procedure.
3
2
.
Make ground lead connections
according to Section 5-7 before
following this procedure.
3
2
1
Terminal Block 1T
2
Interconnecting Power Cord
3
Green Lead (Connected To
Ground In Section 5-7)
Connect
remaining
terminal block as follows:
A: 115 VAC/Neutral Lead
B: 115 VAC/Hot Lead
C: No Connection
D: Dry Contact Closure w/Respect
To Terminal E Lead
E: 115 VAC/Contact Closure Lead
.
For welding power sources
requiring dry contact closure,
move lead 38 at terminal block
to terminal D.
Secure strain relief clamp around
cord.
Reinstall and secure wrapper to
unit.
Connect remaining end of cord to
welding power source.
GND
2 (Red)
4 (Orange)
31 (White)
32 (Black)
1
Terminal Block 1T
2
Interconnecting Power Cord
3
Green Lead (Connected To
Ground In Section 5-7)
Connect
remaining
terminal block as follows:
A: 115 VAC/Neutral Lead
B: 115 VAC/Hot Lead
C: No Connection
D: No Connection
E: 115 VAC/Contact Closure Lead
Secure strain relief clamp around
cord.
Reinstall and secure wrapper to
unit.
Connect remaining end of cord to
welding power source.
leads
to
Ref. 802 310 / Ref. 193 749
leads
to
Ref. 802 310 / Ref. 193 749
Publicité
