Publicité
Les langues disponibles
Les langues disponibles
FAULT
CAUSE
Water inlet closed
No water is input
Incorrect connection to the mains water
into the steam
supply
pipes.
Water inlet filters obstructed by dirt.
Dirty washer
Water leaks out
from the washer
Damaged washer
when the door is
closed.
Door closing mechanism problem
Motor safety thermostat triggered
The fan stops
during operation
Motor condenser breakage
WARNINGS AND ALARMS – DEDICATED TO DIGITAL CONVECTION MODELS
All alarms are indicated by a buzzer. The buzzer can be silenced by pressing a key.
Err = CHAMBER PROBE ALARM:
This is triggered if the chamber probe fails.
progress is interrupted.
WARNINGS AND ALARMS – DEDICATED TO COMBI MODELS
All alarms are indicated by a buzzer. The buzzer can be silenced by pressing a key.
"Er1" CHAMBER PROBE ALARM:
This is triggered if the chamber probe fails. Everything is deactivated except for the light. The cycle
in progress is interrupted.
"Er2" CORE PROBE ALARM
This is triggered if the core probe in the food being cooked fails (where used). Everything is
deactivated except for the light. The cycle in progress is interrupted.
"ALL" MOTOR ALARM
This is triggered if the motor overheats. Everything is deactivated except for the light. The cycle in
progress is interrupted.
Once the alarm is silenced, press the ON/OFF button for 1 second to reset the alarm (the control
panel is set to OFF).
"H-t" CONTROL BOARD TEMPERATURE ALARM
This is triggered if the control board overheats. The cycle in progress is interrupted.
Once the alarm is silenced, press the ON/OFF button for 1 second to reset the alarm (the control
panel is set to OFF).
SOLUTION
Open water inlet
Check connection to the mains water supply
Clean the filters
Clean the washer with a damp cloth
Contact a specialist technician for repairs
(Customer Service).
Contact a specialist technician for repairs
(Customer Service).
Switch the oven off and wait for the motor's thermal
protection to restore automatically. It the problems
persists, contact a specialist technician for repairs
(Customer Service).
Contact a specialist technician for repairs
(Customer Service).
Everything is deactivated except for the light. The cycle in
Publicité
