At the end of the settings for the third phase, press button
phase 4.
You can enter all information regarding the fourth cooking phase (temperature, timer,
steam, etc.).
During the entering of data pertaining to phase 4, the LED light will be on next to all the
phases,
At the end of the setting, press for 5 seconds the key
displayed, indicating that the program has been saved correctly.
IT IS NOT MANDATORY to enter 4 cooking phases in order to be able to save a program.
DELETING A PHASE OR PROGRAM
If you wish to delete a phase from a program, proceed as follows: press the button
the encoder, select the desired program number.
Confirm the choice by pressing the encoder.
Then press the button
for more than 5 seconds
If you wish to delete a program, you must first delete all the phases (as described above). Then
press the button
stored with the phases deleted and has thus been removed).
RETURN TO MANUAL COOKING
To exit the program function and return to the MANUAL cooking mode, hold the ENCODER knob
down until the word "MAN" appears on the display.
OVEN PRE-HEATING
This function is used to compensate for the heat loss that occurs after opening the oven door and
the introduction of food.
To switch on the oven pre-heating function, press the key
(C1)) rotate the encoder in the opposite direction until the caption "INF" appears
LED on next to
(this means infinite time); press the encoder knob to confirm.
You can now proceed to enter other cooking phases.
When you press the key
an increase equal to 20% of the set temperature value; subsequently, an acoustic signal will be
emitted.
The signal is interrupted by opening the door to insert the food in the oven. When the door is
closed, the program pre-set phase will start.
The signal can be stopped without turning the preheating feature on and off by simply pressing the
button
.
(CC1, C2, C3).
until the desired phase has been selected. Keep the button pressed
for 5 seconds until MEM is displayed (it means that the program has been
, the oven will start to pre-heat the cooking chamber until reaching
to move on to the setting of
: the caption "MEM" will be
and on the first phase (with the
and, using