Publicité
Les langues disponibles
Les langues disponibles
TIMER
To set the timer, press
and then use buttons
or
.
Press
to confirm the set time.
The time setting range goes from "---" (infinite) to 999 minutes.
By choosing an infinite cooking time, the oven will keep on working with the set parameters until the
cooking is stopped in manual mode by pressing
.
During a cooking for an infinite time, the lower display shows the time of use in minutes in order to
determine ho long the oven has been working, whereas when cooking with a set time, the lower
display shows the time countdown to the automatic stop.
STEAM
This feature can be used to set a steam value during manual or program cooking.
To set the steam value, press
and then use buttons
or
.
The range of humidity that can be set is as follows: OFF – 20% - 40% - 60% - 80% - 100%.
During programming the values flash on the display, and by pressing
again this value will be
saved.
During the cooking, as steam is generated in the cooking chamber, the LED adjacent to the steam
button lights up.
In case of steams with motor rotation reversal system, the steam supply stops momentarily, for the
entire duration of the reversal.
The set of humidification is allowed only before running a cycle. During the cooking, pressing
generates vapour in the cooking chamber for the entire time it is pressed.
AUTOMATIC PREHEATING
The pre-heating function is automatic in both manual cooking and program cooking.
It consists in preheating the oven to a temperature that is 20% higher than the temperature set in
the first cooking phase. This function is necessary to compensate for the loss of heat when opening
the door to put food in.
When a program starts, the oven first starts this preheat cycle (the upper display shows "PRE" while
on the lower display you can see the actual temperature of the cooking chamber). At the end of the
program, a beep is emitted which stops only when the door is opened.
The previously selected program starts automatically when the door is closed.
The beeping can be stopped by pressing any button.
During the pre-heating phase, it is not possible to use steam.
After the opening and subsequent closing of the oven door, the cooking previously set is started
automatically.
Publicité
