Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
3.2.1 Lever without kill switch model
CAUTION
Avoid bending the cables too narrowly (minimum radius: 200 mm - 8"). The use of ULTRAFLEX cables is
recommended.
Refer to the dimensions indicated in paragraph 1.2 to verify that the control can actually be
1
installed in the chosen position.
After having established the appropriate
2
location, drill the necessary holes to insert the
mechanism with the help of the appropriate
template (supplied). The thickness of the lever
installation surface must not exceed 20mm
(0.7").
Fasten mecheanism (A) to flange (A1) by
4
means of screws (G).
A1
G
A
Installation and maintenance manual
Fasten
the
3
gasket (A2) by means of screws (F).
A1
F
NOTICE
Then, connect the shift cable to the frame and the
rocker arm, as indicated in paragraphs 3.6.
SINGLE LEVER CONTROL B110-ETC
flange
(A1)
and
A2
F
page 11
-
of 67
its
Publicité
