Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
3 INSTALLATION
3.1 Necessary tools
Phillips
screwdriver
(Ø6)
3.2 Control box installation
NOTICE
Depending on the control cables, it is possible to mount
the mechanism in horizontal or vertical position as shown
in the figures on the side, by rotating the internal
mechanism in such a way that the flange inspection hole
matches with the clutch adjustment screw of the
mechanism (see paragraph 3.9).
This consideration is also valid for lever with kill switches
models.
CAUTION
Use the "C" plugs supplied in the screw bag to close two
of the three not used inspection holes in the flange. This
is also valid for lever models with kill switches.
page 10
of 67 -
SINGLE LEVER CONTROL B110-ETC
Flathead
screwdriver (Ø2)
Installation and maintenace manual
14 mm socket
Pliers
spanner
Drill
C
Publicité
