Publicité
Les langues disponibles
Les langues disponibles
Note:
Radio transmission by the Bluetooth
will be enabled on the first time of connection to a
battery, and stay on after that.
1. Download the Husqvarna Fleet Services
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services
fleetservices.husqvarna.com for more information.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
1960 - 002 - 25.08.2023
®
function
™
iOS or
™
website https://
4. When all LEDs on the battery come on, the battery is
fully charged.
A
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
Basic working techniques
WARNING:
cutter to the side. This can prevent the free
movement of the blade and cause the blade
to break, which can cause an injury.
WARNING:
blade. The blade can become damaged and
broken, which can cause an injury. Use only
the cutting edge.
WARNING:
blade to cut plastic material. The heat that
occurs can melt the plastic. Melted plastic
can attach to the cutting blade and cause a
kickback.
•
The product is made for high speed diamond
blades, abrasive blades and recommended blades
for the product. Use Husqvarna recommended
cutting blades for the product.
•
The product is made to cut into tiles, light concrete
and stone. Use only for this type of operation.
•
Make sure that the cutting blade does not show
signs of damage and that it is attached correctly,
Abrasive blades on page 13 and To install
refer to
the cutting blade on page 16 .
•
Always use the correct cutting blade for the type of
Cutting blades on page 12 .
operation, refer to
•
Do not cut asbestos material.
•
Always hold the power cutter with 2 hands. Always
hold the product tightly with thumbs and fingers
around the handles. Always hold the rear handle
with the right hand and the front handle with the left
hand.
B
C
D
Do not move the power
Do not use the side of the
Do not use a diamond
21
Publicité
