Publicité
Les langues disponibles
Les langues disponibles
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.
Cutting blade vibration
CAUTION:
with too much force, the cutting blade
can become too hot, bend and cause
vibrations. Use the product with less force.
If the vibrations continue, replace the cutting
blade.
Applicable cutting blades
CAUTION:
recommended cutting blades for K 540i and
the material to be cut. The recommended
cutting blades decrease the risk of serious
injury and increase the cutting and X-halt
performance. If general high speed cutting
blades are used, the performance and
cutting quality will decrease.
WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such
as circular wood cutting blades or blades
with carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
ANSI B7.1. or EN13236.
1960 - 002 - 25.08.2023
Examine the cutting blade
The cutting blade
If you use the product
Use Husqvarna
Only use diamond blades
Never use a cutting blade
Use only cutting blades
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade
and that of the product is marked on the
type plate.
Note:
Many cutting blades that can be attached to this
product are made for stationary saws. The rated speed
value of those cutting blades is too low for this product.
WARNING:
blades with thickness exceeding maximum
recommended thickness. Refer to
data on page 31 .
•
Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
•
Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.
Abrasive blades
WARNING:
with water. Water or moisture decreases the
Do not use a cutting blade
100 m/s
XXXX rpm
Do not use cutting
Technical
Do not use abrasive blades
13
Publicité
