Publicité
Les langues disponibles
Les langues disponibles
strength of the abrasive blade and increases
the risk that the blade breaks.
CAUTION:
is not permitted with the Vac attachment.
Use of abrasive blade causes too much
wear on the Vac attachment.
WARNING:
on correct material.
•
Do not use wheels from larger power tools. Wheels
of a larger power tool are not correct for the higher
speed of a smaller tool and may break.
•
The cutting material on abrasive blades is bonded
with natural material that have a gravel bonded
agent. Blades that are made up of a fabric or fibre
are stronger. This type of blade does not break if
the blade gets cracks or becomes damaged during
operation.
•
The performance of a cutting blade is given by
the dimension of abrasive grain, and the type and
hardness of the bonding agent.
To examine a bonded abrasive cutting blade
•
Make sure that there are no cracks or damages on
the cutting blade.
•
Hang the cutting blade on your finger and hit the
cutting blade lightly with a screwdriver. If you do not
hear a clear sound, the cutting blade is damaged.
14
Cutting with abrasive blade
Use correct abrasive blade
xxxx
Diamond blades
WARNING:
very hot when used. A diamond blade that
is too hot gives bad performance, blade
damage and is a safety risk.
WARNING:
blades to cut plastic material. The hot
diamond blade can melt the plastic, which
can cause a kickback.
•
Diamond blades have a steel core with segments
that are made of industrial diamonds.
•
Diamond blades are used for masonry, reinforced
concrete and stone.
•
Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
•
Always use a sharp diamond blade.
•
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause
the diamond segments to come loose.
To sharpen the cutting blade
Note:
For the best cutting results, use a sharp cutting
blade.
•
To sharpen the cutting blade, cut into soft material,
such as sandstone or brick.
Diamond blade - requirements
WARNING:
segment (T1) is wider than the blade (T2).
This is to prevent pinching in the cutting slot
and a kickback.
Diamond blades become
Do not use diamond
Make sure the diamond
1960 - 002 - 25.08.2023
Publicité
