Publicité
Les langues disponibles
Les langues disponibles
•
Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.
X-Halt
The X-Halt function is an electronic brake system that is
engaged if a kickback occurs. The function can not fully
prevent personal injury from a kickback, but it decreases
the risk. A safe working technique is necessary to
prevent kickbacks and to decrease the risk of injuries.
The X-Halt function is always on when the product is
on. If the function is engaged, the control panel shows
the X-Halt waning symbol until the product becomes
Troubleshooting on page 28 . For more
cool. Refer to
Troubleshooting on page 28 .
information, refer to
To do before you use the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 25 .
3. Make sure that only approved persons are in the
work area.
4. Make sure that you are in a safe and stable position
during operation.
5. Make sure that the water connector is connected
to a water supply. Refer to
water on page 24 .
6. Do a check of the rear handle (A) to make sure that
it is not damaged.
C
B
A
7. Do a check of the power trigger lockout (B) to make
sure that it operates correctly and that it is not
damaged.
8. Do a check of the control panel (C) to make sure that
it operates correctly.
9. Make sure that all parts and guards are correctly
attached and not damaged or missing.
20
Maintenance
To connect the coolant
10. Charge the battery and make sure that it is correctly
attached to the product. Only use Husqvarna BLi
approved batteries for the product.
11. Make sure that the power cutter stops when you
release the power trigger.
To examine the direction of rotation of the
cutting blade
1. Find the arrow on the blade guard that shows the
direction of rotation of the spindle shaft.
2. Find the arrow on the cutting blade that shows the
direction of rotation of the cutting blade.
3. Make sure that the direction arrow of the cutting
blade and the spindle shaft have the same direction.
To do a check of the arbor bushing
The arbor bushings are used to attach the product to the
center hole of the cutting blade. The product is supplied
with arbor bushings that are applicable for 25.4 mm / 1
in. center holes.
•
Make sure that the dimension of the center hole
of the cutting blade agrees with the installed arbor
bushing. The diameter of the center hole is printed
on the cutting blade.
•
Use only Husqvarna arbor bushings.
®
Bluetooth
wireless technology
Products with built-in Bluetooth
can connect to mobile devices and enables additional
functions from Husqvarna Connect.
Bluetooth
The symbol for
on when your mobile device is connected to the product.
To use embedded connectivity with
Husqvarna Fleet Services
Note:
This part is applicable only for products
supplied with embedded connectivity.
®
wireless technology
®
wireless technology comes
™
1960 - 002 - 25.08.2023
Publicité
