Publicité
Les langues disponibles
Les langues disponibles
To connect the coolant water
1. Connect the water hose to the water supply (A).
A
2. Turn the water valve (B) to start or stop the water
flow.
3. Examine the water connection and the hose for
leakage.
4. Make sure that the water pressure is not higher
than the maximum permitted water pressure, refer
Technical data on page 31 .
to
Dry cutting
•
When dry cutting, lift the blade out from the cut each
30–60 seconds and let it rotate in the air for 10
seconds to let it cool.
•
Use Vac equipment if possible.
To start the product
1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. Refer to
lockout on page 26 .
24
B
2. Put the battery in the battery holder.
3. Push on the lower part of the battery until you hear
a click sound. If the battery does not move into the
battery holder easily, it is not attached correctly into
the battery holder.
1960 - 002 - 25.08.2023
Publicité
