Publicité
Les langues disponibles
Les langues disponibles
Problem
The product is on but the motor
does not start when you push
the power trigger.
The motor is on but the blade
shaft does not rotate.
An unusual noise comes from
the front bearings.
There are unusual vibrations
when the product is on.
The product makes a sudden
movement when you push the
power trigger, then immediately
stops.
The product stops during a
kickback.
The motor makes sudden
movement when you push the
power trigger, then stops.
The product stops when you
apply work load.
LED indicators on the control panel
The LED indicators on the control panel show the state
of charge of the battery and if there are problems with
the product.
LED
Indication
indica-
tor
The indicator
flashes.
1
The indicator is
on.
1960 - 002 - 25.08.2023
Cause
Servicing necessary.
The drive belt is damaged or worn.
The bearings are damaged or worn.
There is a short circuit in the control
unit.
The X-Halt function is engaged.
Servicing is necessary.
There is too much work load on the
product.
Cause
The X-Halt function is engaged.
Servicing is necessary.
Solution
Speak to an approved Husqvarna serv-
ice center.
Replace the drive belt, refer to
move the drive belt on page 27 .
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Wait for the X-Halt to disengage.
Start the product again and apply less
work load.
1
4
3
Solution
Wait for the product to cool down and the X-Halt
function to disengage.
Speak to an approved Husqvarna service center.
To re-
2
29
Publicité
