Publicité
Les langues disponibles
Les langues disponibles
WARNING:
during pipe cutting operation. In all other
operations you must use standard cutting
mode
The pipe cutting mode enables pipe cutting in the
kickback zone.
1. Move the stop bolt of the blade guard from the
standard cutting mode (A) to the pipe cutting mode
(B).
A
2. Pull the adjustment handle to enable the pipe cutting
mode.
1960 - 002 - 25.08.2023
Only use pipe cutting mode
B
3. Put back the stop bolt to the standard cutting mode
after the pipe cutting operation. The arrow (A) shows
the standard cutting mode.
A
Wet cutting
CAUTION:
together with the wet system.
•
Diamond blades for wet cutting must be used with
the wet system.
•
Water cool the blade and increases its service life
while also decrease the dust.
•
When wet cutting, make sure to collect the waste
water safely.
To decrease dust during operation
The product has a wet cutting kit to decrease harmful
dust in the air during operation. The wet cutting kit has
low water consumption.
•
When possible, use wet cutting blades with water
Diamond blades for wet cutting on
cooling. Refer to
page 15 .
•
Adjust the water flow with the valve. The correct flow
is different for different types of tasks.
•
Make sure that the water pressure is correct. Refer
Technical data on page 31 . If the water hose
to
comes off at the supply source, the supplied water
pressure can be too high.
Do not use Vac equipment
23
Publicité
