Publicité
Les langues disponibles
Les langues disponibles
Inspect the burners at least once a year or immediately after any of the following occurs:
The smell of gas and the burner fl ames appearing yellow.
»
The grill does not reach temperature.
»
The grill heats unevenly.
»
The burners make popping noises.
»
Storing the Grill
The gas must be turned off at the supply cylinder when the unit is not in use.
»
Place a dust cap on the cylinder valve outlet when the cylinder is not in use. Only install the type of dust cap on the cylinder
»
valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.
If the appliance is stored indoors, the LP gas tank must be disconnected and removed from the grill. LP gas tanks must be
»
stored outdoors in a well-ventilated area out of the reach of children.
Troubleshooting
If the grill is not functioning properly, try the following solutions.
NOTICE
For more FAQ and information, go to www.amazon.com/dp/B0B8R53VTJ
Problem
When attempting to light my grill, it will not light immediately.
Solutions
Make sure that the liguid propane tank is not empty.
»
Make sure that you have a spark while you are trying to light the burner. If no spark, make sure that the battery is
»
installed properly.
Make sure that the wire is connected to the electrode assembly.
»
Clean wire(s) and / or the electrode with rubbing alcohol and a clean swab. Wipe with a clean cloth.
»
Check to see if the other burners operate. If so. check the gas orifice on the malfunctioning burner for an obstruction.
»
Problem
Regulator makes noise.
Solutions
The vent hose on the regulator may be plugged or the regulator may be faulty. Make sure that the vent hole on the
»
regulator is not obstructed. Clear the hole and close the gas control valves. Wait ten minutes and re-start.
Check your flames for proper performance. If the flames are not correct, replace the regulator.
»
Problem
Low heat with the control knob set to the High setting.
Solutions
Make sure that the fuel hose is not bent or kinked.
»
Make sure that the grill area is clear of dust.
»
Make sure that the burner and orifices are clean.
»
Make sure that an adequate gas supply is available.
»
Make sure that the grill has been preheated for 15 minutes.
»
Check for spiders and insects.
»
The regulator has a safety device that restricts the flow of gas in the event of a leak. This safety device can be triggered
»
without a gas leak. To reset the safety device, turn off all burners and close the LP tank valve. Disconnect the regulator
from the LP tank and wait one minute. Reconnect the regulator to the LP tank and slowly open the LP tank valve until the
valve is fully open. Light all burners and observe the temperature.
EN
19
Publicité
