Patek Philippe ANNUAL CALENDAR WITH 24H INDICATION Mode D'emploi page 8

PREPARATIONS
1. If your watch has stopped running, rewind it by
hand before performing any corrections or adjust-
ments (about 10 clockwise turns of the crown).
2. You can be sure that performing adjustments is
safe if you first set your watch to 6 a.m.; observe
the 24-hour dial to distinguish between 6 a.m.
and 6 p.m.
3. Make sure to set the date to the first day of the
month with the correction push piece at 4 o'clock.
DATE CORRECTION
To set the date , actuate the correction push piece
at 4 o'clock as many times as needed to display
the current date.
12
MONTH CORRECTION
To set the month , actuate the correction push
piece at 2 o'clock as many times as needed to
display the current month.
DAY-OF-WEEK CORRECTION
To set the day of the week , actuate the correction
push piece at 10 o'clock as many times as needed
to display the current day.
MOON-PHASE
CORRECTION
Each time the correction push piece
actuated, the moon-phase disk will advance by one
day. To begin the correction procedure, advance the
moon-phase disk until a full moon is displayed in the
middle of the aperture. Consult an almanac or visit
www.patek.com and count the number of days that
have elapsed since the last full moon (relative to the
current date). To set the correct moon phase, press
the correction push piece as many times as the num-
ber of days that have elapsed since the last full moon.
13
at 8 o'clock is