Télécharger Imprimer la page

Atag HIDD8471E/A01 Instructions D'utilisation Et De Montage page 45

Induction avec aspiration intégrée

Publicité

Les langues disponibles

Les langues disponibles

Operation
4.25.2 Fan time lag
The fan time lag is used after cooker in order to remove
cooking odours. The lter is also dried in the fan.
Setting the fan time lag
1. Select the fan indication.
2. Then use the Plus key
to set the required time for the fan time lag.
Left position:
Centre position:
Right position:
3. After a few seconds your input will be assumed and the
procedure will have commenced.
The timer symbol
4. The fan will be switched off when the time has lapsed.
If a cooking zone is switched on, the timer does not run
until the cooking zone has been switched off . If the hob is
switched off using the On/Off key during fan after run-time,
the timer runs down to a low fan level.
4.25.3 After run time
The fan motor should continue operating for another
10 - 20 minutes every time the hob has been used for
cooking.
If the fan is in operation and no fan run-on is set, there is an
automatic run-on of 5 minutes at level 1 after switching off .
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air lter, please always allow for
a stop delay time of 10 - 60 minutes in order to optimally
remove cooking odours.
When the fan is switched on again, in rare cases the odour
molecules present in the lter may be combined with steam
so that they are detected again. These remaining odours will
disappear when the fan continues to operate.
NOTE
When the convection air mode is in operation, ventilation
must be suffi cient in order for the air humidity to be
removed.
Replacement of the lter
If an existing carbon lter must be cleaned or replaced, this
is indicated in the fan display by a
operation).
When the fan is switched on, the display for a cooking
process is deleted.
To reset the display, the fan display and the sensor eld must
be pressed simultaneously for approx. 3 seconds.
If no carbon lter is used, the display indication
be reset.
or the Minus key
hours
every 10 minutes
every minute
of the fan lights up.
(after 150 hours of
GB
of the timer
must also
45

Publicité

loading

Ce manuel est également adapté pour:

Hidd8471e