Publicité
Les langues disponibles
Les langues disponibles
Suitable for induction cooking
38
Operation
4.10 Permanent pan recognition
If the hob has permanent pan recognition, a cooking setting can
only be switched on via the sensor fi eld after a pan has been
detected on the hob and the power display shows 0.
4.11 Operating the keys
The controls described here expect the pressing of a (selection)
key to be followed by the pressing of a subsequent key. The next
key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.
4.12 Switching on the hob and cooking zones
1. Press the ON/OFF key
2. Use the power setting display (as a key) to select a cooking
3. The touch control
Stand-by dot
4. Immediately put cookware suitable for induction cooking onto
4.13 Switching off a cooking zone
Use the power setting display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected must light
up.
5. a) Press the sensor fi eld on the far left
4.14 Switching off the hob
6. Press the ON/Off key of the hob
Please note:
The hob will switch off automatically after 10 seconds when all
the cooking zones are switched of manually (power setting 0)
and no key/sensor fi eld is pressed afterwards.
* The Power boost function is activated immediately. See the
section on Power setting.
setting 0 appears and a short signal will sound. The controls
are ready for operation.
The permanent pan recognition recognizes on which cooking
zone a pan is set up and shows a 0 in the corresponding
power setting display.
zone. The stand-by dot of the cooking zone selected will light
up.
afterwards. A power setting will be switched on.
.......left
.......center
.......right
See the section on Worth knowing about the slider (sensor
fi eld)
Press the respective sensor fi eld
power setting or to switch on an additional cooking zone.
Important: the stand-by dot of the cooking zone selected must
light up.
the cooking zone. The pan recognition device will activate the
induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and
the symbol
. If no pot is placed on the cooking zone it will
switch off after 10 minutes for reasons of safety. Please refer
to the Section on pan recognition.
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0.
off , irrespective of any settings.
(approx. 1 sec.) until the power
must be activated immediately
Power setting 0.
Power setting 5.
Power setting P*
to change a
or
. The hob will be switched
GB
Publicité
