Clean Nozzles; Automatic Nozzle Cleaning; Manual Nozzle Cleaning; Selecting Cleaning Interval - Reiner jetStamp 790 Mode D'emploi

jetStamp 790/790 MP

5.3. Clean Nozzles

If there is stripe formation or if any problems occur with the print quality, there may be dried
14
ink in the nozzles .
To warrant high print quality, the nozzles
For notes on temperatures and humidity, see "Technical Data" page 89 and in the
accompanying documents of the cartridges.
To avoid drying of the ink at the nozzles
matic conditions of the environment (see "Selecting cleaning interval", page 72).

5.3.1. Automatic Nozzle Cleaning

WARNING
Danger of blinding at contact of the ink with the eyes.
Do not point the jetStamp 790's nozzles
f
Trigger automatic cleaning mechanism
A small amount of ink is ejected to clean the nozzles
Put jetStamp 790 in charging station
f
Push [MODE] until the display menu bar [CLEAN] appears.
f
To start cleaning, push [CLEAN].
f

5.3.2. Manual Nozzle Cleaning

Manual Nozzle Cleaning
If automatic nozzle cleaning does not bring the desired result,
we recommend the following measure:
To loosen the dried ink, gently wipe a soft cloth possibly moistened slightly with Ethanol
f
(spirit) against the nozzles
Dab off dissolved ink and wipe dry the nozzles
f

5.4. Selecting Cleaning Interval

See "Cleaning Interval", page 72.
f
14
should be cleaned at regular intervals.
14
14
towards the face of persons!
Fig.

4
.
Fig. E

14
for approx. three seconds.
, adjust the cleaning interval to the cli-
A
14
.
14
.
GB
85