Important Information; Batteries; Changing The Batteries - Reiner jetStamp 790 Mode D'emploi

jetStamp 790/790 MP

Important information

Before using the jetStamp 790/790MP for the first time, the operating manual must be read
through, paying careful attention to the safety advice. In this way, you can avoid uncertain-
ties and their accompanying safety risks when working with the electronic stamp, for the sake
of your own safety and to prevent damage to the device.

Batteries

Battery charging is electrinically controlled. This guarantees that the battery cells are char-
ged in a way that is both optimised and gentle
Charging
Completely charge the batteries before using the stamp for the first time.
f
This takes about 14 hours. After this, charging time is a maximum of six hours.
The batteries do not reach their full capacity after the first charging.
You must work on the basis that normal standby times will not be achieved.
Reaching full capacity
Full capacity is reached after the batteries have been fully discharged and charged a
number of times.
The batteries are fully discharged when [EMPTY BAT] appears in the display.
The batteries are fully charged when the green charging control light is out.

Changing the batteries

The display is reset when the batteries are removed. The jetStamp 790/790MP must then be
inserted into the charging station for about three hours in order to synchronise the battery
capacity display.
GB
53